Limb Tremor

Description

The “Limb Tremor” is designed to be mounted on utility and compact tractors specifically for trimming tree limbs and also cutting brush. Its design allows the attachment to be used as a traditional front mounted cutter/mower with the ability to reposition the cutter to an off-set side mower, bank/ditch mower (-10 to +45 degrees), and a vertical limb trimmer. Change from one position to another in a matter of minutes.

N

1-year limited warranty: Commercial and Rental

N

30"-40" wide cut, vertical height up to 13 feet depending on tractor model

N

12 gage steel with a 5/16th inch reinforced spindle plate

N

Blade speed 980 rpm at tractor pto speed of 540 rpm

N

Blade can start in any position

N

0 - Full RPM in 5 seconds

P

Replaceable skid shoes

P

Utilizes a saw blade instead of free-swinging blades for unmatched safety and a clean cut

P

Flexible rear discharge deflector flap

P

Spring loaded blade guard

Models

Model MPT30 Limb Tremor

Specs
Cut 30″ wide, vertical height up to 13 feet depending on tractor model

Deck Articulated deck -10 to +45 degrees with float wheel for bank mowing

1/4″ x 2 1/2″ x 2 1/2″ angle reinforcement

Blade 30″ diameter, 1/4″ 5 gauge) thick Hi-flex non-cracking alloy steel

Saw blade to insure a clean cut

Drive One piece cast iron spindle housing – 2″ forged shaft w/ forged flange – tapered roller bearings in oil bath

Danfoss Hydraulic Motor (10 or 15 gpm – depending on tractor size) with 13 tooth splined drive – Works at 75% capacity vs. 150% – 200% capacity on most motors

Model MPT40 Limb Tremor

Specs
Cut 40″ wide, vertical height up to 13 feet depending on tractor model

Deck Articulated deck -10 to +45 degrees with float wheel for bank mowing

1/4″ x 2 1/2″ x 2 1/2″ angle reinforcement

Blade 40″ diameter, 1/4″ 5 gauge) thick Hi-flex non-cracking alloy steel

Saw blade to insure a clean cut

Blade speed 980 rpm at tractor pto speed of 540 rpm

Drive One piece cast iron spindle housing – 2″ forged shaft w/ forged flange – tapered roller bearings in oil bath

Danfoss Hydraulic Motor 15 gpm with 13 tooth splined drive – Works at 75% capacity vs. 150% – 200% capacity on most motors